Step drill OREN with spiral flute HSS-Co.TiAIN - 4-20 mm (2 mm step)

Step drills HSS-Co. TiAIN with spiral flute

Step drills are used for drilling cylindrical holes, which edges are at the same time knocked down by the next step.

Drilling into material up to 6 mm thick.

Design:

• cobalt content 5%
• Titanium-Aluminum-Nitride (TiAlN) coated
• drilling diameters are clearly marked on the individual steps
• provided with a spiral groove and a deburring zone
• the spiral groove ensures better chip removal and faster and calmer drilling
• the deburring part is used to deburr the underside of the processed material
• the tip is equipped with a cross cut - punching and drilling is completely eliminated

Include diameters: 4-20 mm (at 2 mm intervals) (4-6-8-10-12-14-16-18-20)

Advantages compared to HSS step drills:

• higher heat resistance
• faster drilling
• longer lifetime
• increased surface hardness
• no need to use threading oil
• the features of this tool remain even after regrinding

Used in: alloy steel, non-alloy steel, iron, cast iron, non-ferrous metals, V2A stainless steel, V4A stainless steel, steel with strength up to 1200 N / mm2, drilling holes in sheets, pipes, profiles, CrNi steel, non-ferrous metals, plexiglass, wood

Packed in: tubes for hanging

Note: please use lower speed when drilling in stainless steel material